Signal Testing Guide

Combined with all of the steps in the 'Test Kit - Quick Start Guide':

Truety wireless modules are designed to optimize their communication parameters based on the RF environment, maximizing transmission performance and battery life.

Typically, once a wireless module has been installed, its location is permanent. This differs from signal testing scenarios where the module will be moved to different locations during testing. For the purpose of signal testing, you will use only the device rejoin request function in the Truety CX App.

See the attached PDF for instructions on signal testing.

• Related Articles

• Truety Test Kit - Quick Start Guide

  Use the login credentials provided by QMC Metering Solutions, or use the following link to register an account: https://portal.truety.com/register Download Truety Commissioning app from the App Store: (coming soon) Or download the Android APK file ...

• Truety - Mobile app guide

  Attached is a Truety mobile app guide.

• Truety NFC Guide

  Truety NFC Guide NFC Technology Truety app utilizes NFC (Near Field Communication) technology to communicate with the system components. To take advantage of the effortless process of commissioning the meters on site, referred to as “Tap and Go” ...

• Truety Gateway Installation Guide

  1. Install the Gateway • Use the mounting hardware to mount and ground the Gateway • Use the Ethernet port to power up the Gateway (120V PoE injector is included with the Gateway. Use PoE port) • Connect the LoRaWAN antenna to the Gateway 2. Check if ...

• Truety Indoor Gateway - Installation Guide

  Truety Indoor Gateway - Installation Guide 1. Install the Gateway • Mount the gateway on a flat surface with M3 screws with 2.4” center spacing, leaving the screw heads protruding with a 3 mm gap from the wall surface. • Connect the LoRaWAN antenna ...